No appropriate method, property, or field 'analogRead' for class 'arduino'.

Question

Mohammed Al-Mostafa 2015-5-18

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/217451-no-appropriate-method-property-or-field-analogread-for-class-arduino

编辑： Manohar Patel 2018-10-19

I connect my arduion to matlab and everything is fine but when I tried to read the values that is come from LM32 sensor which I connect to port A0 by using analogRead(a,0) I get this error No appropriate method, property, or field 'analogRead' for class 'arduino'. **I am using matlab 2015 a

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Walter Roberson 2015-5-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/217451-no-appropriate-method-property-or-field-analogread-for-class-arduino#answer_179567

analogRead() needs to be done in the code on the arduino side, not on the MATLAB side. See some sample code

5 个评论
显示 3更早的评论隐藏 3更早的评论

Walter Roberson 2015-5-19

The LM32 does not output analog signals. The LM32 outputs digital signals on its SWD pin. The Master (arduino in this case) must signal the LM32 that it wants to read, and there is a protocol. See http://pdf.datasheetcatalog.com/datasheet2/a/0s6d7g5uzse6i36klqax64y9lcpy.pdf

I would suggest that what you were looking at was instructions for an LM35 sensor, as LM35 sensors encode their readings as voltage outputs.

There is a possibility that one of these will be of assistance to you:

Before I do any more research, please confirm that you are using an LM32 Temperature Sensor, from National Semiconductor. There are a number of different temperature sensors from different manufacturers and will similar names, but which have quite different interfaces.

Walter Roberson 2018-4-9

It turns out that analogRead() did exist, but it was for the Legacy arduino package. https://www.mathworks.com/matlabcentral/fileexchange/32374-legacy-matlab-and-simulink-support-for-arduino

请先登录，再进行评论。

Answer 2

Manohar Patel 2018-10-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/217451-no-appropriate-method-property-or-field-analogread-for-class-arduino#answer_342195

编辑：Manohar Patel 2018-10-19

Hii @Mohammed Al-Mostafa your error is "No appropriate method, property, or field 'analogRead' for class 'arduino'". please 'analogRead' swap with 'readVoltage'. because some attributes are change in matlab2015.