FFT of a selected range of points

2 次查看（过去 30 天）
Aqua22
Aqua22 2015-6-5
回答： Salaheddin Hosseinzadeh 2015-6-5
I have a waveform as the one attached and I need to perform FFT over a small section of this waveform (like the one highlighted by a rectangle). How can I do that? I don't have any prior experience of working in frequency domain. Any help would be greatly appreciated.

请先登录，再回答此问题。

采纳的回答

Rushikesh Tade
Rushikesh Tade 2015-6-5
if you know the time where it started you can simply do it by using:
fft(signal(initial_time:final_time))

更多回答（1 个）

Salaheddin Hosseinzadeh
Dear Aqua,
Please be aware. You probably going to need a window! If you only take the fft of a section without properly separate it from the rest of the data you will end of with some unwanted artifacts in the frequency domain.
You should either use spectrogram or apply an appropriate smoothing window to your time domain signal. Basically spectrogram does the same thing. Otherwise the result may be inaccurate.

类别

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by