Simulink Model made in Matlab 6.5.1 (R13SP1) doesnot work in higher versions
显示 更早的评论
Hi reader,
I have made a Simulink model in Matlab 6.5.1. I tried running it in R2008 and R2010 but it doesn't run properly. It starts showing error when I run the same model. While the same model runs in 6.5.1.
(To be specific it shows error with lqry command in higher versions)
Can somebody guide me on this? Also On which other version shall it possibly run?
Thanks
回答（3 个）
Walter Roberson
2011-12-28
0 个投票
Do you have the Control System Toolbox installed and licensed with those later MATLAB versions? http://www.mathworks.com/help/toolbox/control/ref/lqry.html
Tigmanshu
2011-12-28
0 个投票
Fangjun Jiang
2011-12-28
0 个投票
Open your old version of Simulink model in the new version of Simulink software and do a save-as. Pay attention to any messages show up in the Command Window.
Or run slupdate(Model, 'OperatingMode', 'Analyze') to see what blocks need your special attention.
类别
在 帮助中心 和 File Exchange 中查找有关 Interactive Model Editing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
