No output on scope

Nasif

2015 10 31

1 个回答

6 次查看（30 天）

0 个投票

Hi, I'm trying to model an RFID tag in this block that modulates a signal if input power is above a certain threshold. However when I run the simulation, there is no output of scope. The power meters change showing the values update, however scope has no trace, no even the first one which is just supposed to plot a sin wave.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

回答（1 个）

Tushar Sinha 2015-11-3

0 个投票

Hi Nasif,

I understand that you are not able to see any plot in the Simulink Scope Block. However, if you refer to the following MathWorks documentation link, it talks about the same issue and what troubleshooting steps you can take to resolve it:

plots-not-visible-in-simulink-scope-block

I hope this helps resolve the issue.

Thanks,

Tushar