清空筛选条件
清空筛选条件

How can i avoid the error coming when I am making some elements dead in an array in antenna toolbox in Matlab R2015a.???

1 次查看（过去 30 天）
guruprasad mishra
guruprasad mishra 2015-11-10
回答： Vishwanath Iyer 2015-11-13
I am using antenna toolbox to design a rectangular array. when I am going to make some element dead by making their feed to zero, an error comes as following. so please help me to avoid that error.
Code:
%%%J.M.T.&.M.+.MAA
clc
clear all
close all
d = dipole;
N = 5;
df = repmat(d,N)
r = rectangularArray('Element',df);
show(r)
S = [1:2:N*N];
for i = 1:25
if any(S==i)
r.Element(i).Tilt = 90;
r.Element(i).TiltAxis = [0 1 0];
end
end
figure;
show(r)
figure;
pattern(r,75e6)
Vfeed = ones(1,N*N)
Vfeed(S) = 0
r.AmplitudeTaper = Vfeed
figure
pattern(r,75e6)
Error:
Error using em.Array/set.AmplitudeTaper (line 125)
Expected input to be positive.
Error in paa_test4 (line 23)
r.AmplitudeTaper = Vfeed

请先登录，再回答此问题。

回答（1 个）

Vishwanath Iyer
Vishwanath Iyer 2015-11-13
Hello Guruprasad,
In the R2015a release of Antenna Toolbox, it is not possible to set the AmplitudeTaper to zero. In the R2015b release however, this is possible.
As a workaround, try setting it to a really small value, e.g. 1e-16. So the following line would be: Vfeed(S) = 1e-16
Hope this helps.
Regards,
Vishwanath

类别

在 Help Center 和 File Exchange 中查找有关 Antenna and Array Analysis 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by