Hello!
Basis:
- Simulink-model runs with discrete solver (ode3) at solverstep = 0.1 second
- Stateflow-chart with about 20 transitions
- For testing, I implemented the same decision-logic from Stateflow as simple Simulink-blocks.
Now, if I run the simulation and scope the Stateflow-decisions (blue) versus the Simulink-decisions, Simulink (red) runs always faster.
For better understanding, I attached this scope.
I watched Stateflow stepping through the states and observed that it takes not only one step for the whole diagram but multiple steps to move through. Eventually this produces large errors.
One solution would be to take smaller solversteps. If I take steps like 0.01 instead of 0.1, it gets much better - but at the expense of calculation time.
Is there any possibility to force Stateflow to go through the chart within one solverstep, or is this a conceptual thing, or depending on the chart's construction? I already searched the preferences but did not find an appropriate seeting.
Thanks for your time and for any approach to a solution.
AL
