Figure title/labels in LaTex cutoff
显示 更早的评论
Hi. If you run a code like title('$$\frac{1}{2}$$','interpreter','latex','fontsize',20) Matlab will set the title '1/2' on a figure window, neatly written in LaTex. However, the estimated size of this text is smaller than it really is, so the upper most part is cut off from the figure (hidden underneath the menubar)
I've tried to come up with a general solution using position, outerposition, extent, etc... But I haven't had any luck. The same is the case for x- & ylabels, written with LaTex.
Anyone out there who has a solution, or is up for the challenge to find one? Thank you!
回答（4 个）
jay
2012-4-27
I found this suggestion from http://automatica.dei.unipd.it/tl_files/utenti/varagnolo/matlab/HowToMakePrettyFiguresWithMatlab.pdf
% in order to make matlab to do not "cut" latex-interpreted axes labels %
set(gca, ’Units’,’normalized’, ’Position’,[0.15 0.2 0.75 0.7]);
Then play around with the values in 'Position' until the frame looks right.
Fangjun Jiang
2011-3-7
0 个投票
what if you adjust the font size? title('$$\frac{1}{2}$$','interpreter','latex','fontsize',10) looks acceptable to me when the figure is in its default window size.
title('$$\frac{1}{2}$$','interpreter','latex','fontsize',20) looks good when the figure window is in full screen.
Germán
2011-5-17
0 个投票
I also get the same issue with the Tex interpreter, it usually cuts the \rangle or \langle character in ylabel or xlabel depending the font size.
Peter
2012-3-22
编辑：Walter Roberson
2017-11-15
xlabel('time $t$','Interpreter','latex');
fig('units','centimeters','width',14,'height',4,'font','Helvetica','fontsize',16)
类别
在 帮助中心 和 File Exchange 中查找有关 Title 的更多信息
产品
2011-3-6
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
