How do I continuously write to a file by using a loop?

Question

yc j 2016-1-25

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/265182-how-do-i-continuously-write-to-a-file-by-using-a-loop

评论： Geoff Hayes 2016-1-26

采纳的回答： Geoff Hayes

在 MATLAB Online 中打开

Hello, I have a question about continuously writing to a file, not over writing by using a loop.

For simple example, I have a code as below:

for i=1:5
    a=i;
    b=a*2;
    AA = [a; b];
    fileID = fopen('AB.txt','w');
    fprintf(fileID,'a','b');
    fprintf(fileID,'%12.8f %12.8f\n',AA);
    fclose(fileID);
end

I want AB.txt to have all the values like a=[1 2 3 4 5] and b=[2 4 6 8 10]

However, above code will only write a=5 and b=10, and i guess this is due to overwriting.

1. How can I get the data continuously? I have to use the loop.. Above is just a very simple example.

2. If I only want the values of a to be on the text file, how should I make the code?(the examples I could find always have two sets(a & b) of data.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Geoff Hayes 2016-1-26

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/265182-how-do-i-continuously-write-to-a-file-by-using-a-loop#answer_207418

编辑：Geoff Hayes 2016-1-26

Open the file and write the header outside of the for loop. Then within the loop, write the two elements to file. Then, once all iterations have completed, close the file (again outside of the for loop).