Simulink Send / Receive data model Example

1 次查看（过去 30 天）
Raymond Chiu
Raymond Chiu 2016-2-10
编辑： Raymond Chiu 2016-2-10
Built and attached example described in this link: http://www.mathworks.com/help/instrument/building-simulink-models-to-send-and-receive-data.html
Error Messages:
Error using serial/fopen (line 72) Open failed: Port: COM1 is not available. Available ports: COM9, COM15. Use INSTRFIND to determine if other instrument objects are connected to the requested device. Error using serial/fopen (line 72) Open failed: Port: COM1 is not available. Available ports: COM9, COM15. Use INSTRFIND to determine if other instrument objects are connected to the requested device. Error using serial/fprintf (line 144) Unexpected error: OBJ must be connected to the hardware with FOPEN..
Observations:
  • same errors with attempt to perform exercise with COM2
  • block settings only allow COM1-COM4, not COM9, COM15
  • device manager show COM8, COM9 COM15 in use
Questions
  • Why is COM1 unavailable? COM2?
  • How to make COM1 'available'?
Diagnostic questions are good: actionable suggestions are appreciated. Examples are preferred. *Thank you*

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Instrument Control Toolbox Supported Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by