Measured rms value through Simulink with STM32F407 is varying very slowly after changing input?

2 次查看（过去 30 天）
muhammad saad malik
评论： muhammad saad malik 2018-3-12
I am using STM32F407 microcontroller with Simulink. After taking the input samples through ADC i convert it to voltage and then measure the rms value using RMS block in DSP system toolbox. I have used running rms for rms computation. I am getting the measured rms value at the LCD but when i remove the input i.e. 0V, the LCD or even LEDs do not respond instantaneously rather the value starts decreasing and gets to zero in almost minutes i.e. 4-5 min from 115V. I want help to understand what is the reason for this slow response in rms computation and is there any solution for it?

请先登录，再回答此问题。

回答（2 个）

nitish agarwal
nitish agarwal 2016-5-3
Hey, I am facing the same difficulty. I am using DRMS block. If u have rectified the problem then pls let me know
  1 个评论
muhammad saad malik
muhammad saad malik 2016-5-18
use the rms block in dsp system toolbox with "entire input" as the selection preceded by a buffer with number of samples in one cycle as the value in first box. Leave the remaining boxes as it is.

请先登录，再进行评论。

Ahmet yüksel
Ahmet yüksel 2018-3-12
Hey, I am facing the same difficulty. I am using DRMS block. If u have rectified the problem then pls let me know. how to solve this error. may you help me please
  1 个评论
muhammad saad malik
muhammad saad malik 2018-3-12
use the rms block in dsp system toolbox with "entire input" as the selection preceded by a buffer with number of samples in one cycle as the value in first box. Leave the remaining boxes with their default values.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Signal Generation, Manipulation, and Analysis 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by