Set up graph before going into for loop, then refresh data in plot after each iteration

20 次查看（过去 30 天）
monkey_matlab
monkey_matlab 2016-4-3
编辑： Kuifeng 2016-4-3
In this program, I wanted to know if it is possible to update just the data points during the for loop, but keep the graph setup the same throughout the for loop process. I tried setting up the graph at first, like the axis, labels and legend ( I had a problem with the legend), then go into the for loop and just refresh the data. In the program below, after each iteration, the old data remains and the graph just keep adding the new data points without getting rid of the old ones. I tried clf, but that command clears the whole graph and I would have to start back from the beginning to set back up the graph.
Is it possible to just refresh the data points after each iteration, or do I have to draw the graph over each time?
Here is the code that I have so far:
N = 10;
h2 = [];
h3 = [];
%%Plot of Original and OMP Signals
figure(1); clf;
axis([1 N -3 3]);
h=xlabel('index [1 to m]');
legend([h2,h3],{'x-Original','x-OMP'})
set(h,'FontSize',14);
ylabel('Amplitude');
set(h,'FontSize',14);
set(gca,'FontSize',14);
Iter = 5;
for ii = 1:1:Iter
if ii == 1 % This is done so as to plot the legend only on the first iteration
A = rand(1,N);
C = rand(1,N);
B = 1:1:N;
pause(1);
%h1 = plot(A);
hold on;
h2 = plot(B,A,'.r');
set(h2,'MarkerSize',15);
h3 = plot(B,C,'.b');
set(h3,'MarkerSize',7);
legend([h2,h3],{'x-Original','x-OMP'});
else
A = rand(1,10);
B = 1:1:N;
C = rand(1,N);
pause(1);
%h1 = plot(A);
hold on;
h2 = plot(B,A,'.r');
set(h2,'MarkerSize',15);
h3 = plot(B,C,'.b');
set(h3,'MarkerSize',7);
end
end

请先登录，再回答此问题。

回答（1 个）

Kuifeng
Kuifeng 2016-4-3
编辑：Kuifeng 2016-4-3
turn off the 'hold'
"...
%hold on;
...
%hold on;
..."

类别

在 Help Center 和 File Exchange 中查找有关 Line Plots 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by