code generation using simulink

4 次查看（过去 30 天）

Waqas Khan 2012-2-7

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/28322-code-generation-using-simulink

编辑： kheirou 2013-10-6

Hi, i am a university student. i am trying to generate a code for ccs4( for c2000 piccolo f28035 microcontroller). but whenever i try to generate , i get the following error "The left-hand side of a . operator must be a valid scope identifier".

i dont know what to do.kindly help.

regards, waqas

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

回答（3 个）

Kaustubha Govind 2012-2-7

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/28322-code-generation-using-simulink#answer_36613

Support for CCS 4.0 was only recently added (I think it was R2011a). Also, you need to use the XMakefile configuration for CCS 4.0. If you are using a newer version of MATLAB, follow the steps on Tutorial: Using Makefiles with Code Composer Studio 4.x and see if that helps.

6 个评论
显示 4更早的评论隐藏 4更早的评论

Siva Aduri 2012-5-19

i am also trying to interface piccolo micro controller and i have followed the steps given but still it is showing could not build

Please help because i have tried it so many times

Kaustubha Govind 2012-5-21

Siva: If you've already followed my advice to Waqas and still were not able to resolve the issue, you should probably contact MathWorks Tech Support.

请先登录，再进行评论。

Gurudev 2012-12-10

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/28322-code-generation-using-simulink#answer_68038

I also had a hard time getting Matlab and Simulink to work with CCS. There is one good video that helped me start. I found it a bit long but it has all the steps needed, from installation to generating code for a simple Simulink model: It works for CCSv3.3 which is older but has automatic download and run from Matlab

http://youtu.be/kiVOA5Js7Ag

The same video exists for CCSv4/5: http://youtu.be/7ed1NLD817s

I hope it helps.