Chirp Signal Block in MATLAB

2 次查看（过去 30 天）
Teo Samuel
Teo Samuel 2012-2-12
编辑： Image Analyst 2013-10-19
Hi,
I would like to ask whether it is possible to adjust the magnitude of the chirp signal or not? Because the default amplitude of the chirp signal block is 1 volt, and I would like to get the chirp signal magnitude of 5V-6V. How can I adjust it?? Or csn I put a gain block of 5 after the chirp signal block?
Please advice, thank you very much.
Regards

请先登录，再回答此问题。

采纳的回答

Kaustubha Govind
Kaustubha Govind 2012-2-13
Yes, since there is no amplitude parameter, you can simply place a Gain block after it to achieve the desired frequency.
  3 个评论
显示 1更早的评论
Kaustubha Govind
Kaustubha Govind 2012-2-21
Teo: Sorry, I don't have enough experience with system modeling to answer that question with any authority. Perhaps you could post this as a new question on MATLAB Answers so that other experienced users can weigh in?
Teo Samuel
Teo Samuel 2012-2-22
Dear Miss Kaustubha Govind,
Actually, I already posted the relevant question for sometimes, but nobody answer it. Anyway, thank you very much for your help.
Regards

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Linear Model Identification 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by