How to set the input and target in power state estimation using neural network?

1 次查看（过去 30 天）
Hossam Mosbah
Hossam Mosbah 2016-7-14
评论： Dina Elsafy 2023-12-20
I am doing an experiment on power system state estimation using neural network  for IEEE 14 bus system with fully observed. Fully observe means all sensors are working and all measured data from sensors are transmitted to the control center. So I set the input as measured data (available measurements) and target as the true state variables (load angle and magnitude voltage), however  the measured data (input) has different samples from the target (state variables), so can we set every type of input as vector. For example, active power injections as a first vector (row) in the input matrix, reactive power injections as a second vector (second row) and the same for active power flow and reactive power flow. Or it is wrong and we have to set all measurements as one vector as we do when we use weighted least square, kalman filter, linear programing and so on. 
  3 个评论
显示 1更早的评论
Dina Elsafy
Dina Elsafy 2023-12-20
Hi Sir,
Iam doing a research in the area of Deep learning state estimation in power system , please can you send to me the model and code of the above work.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Greg Heath
Greg Heath 2016-7-14
For N pairs of I-dimensional "I"nputs and resulting O-dimensional "O"utput targets
[ I N ] = size(input)
[ O N ] = size(target)
Hope this helps
Thank you for formally accepting my answer
Greg

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Online Estimation 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by