Turn off compile mode

29 次查看（过去 30 天）
Simon Yngve
Simon Yngve 2012-2-21
评论： rsating 2024-6-27
Hi,
I use Model([], [], [], 'compile') to set the model in compile mode before computing some checksums. After receiving the checksums I want to close the model but I get an error that the model can't be closed since it is being compiled.
How do I turn off the compile mode?

请先登录，再回答此问题。

采纳的回答

Kaustubha Govind
Kaustubha Govind 2012-2-21
Run the following command to terminate simulation:
>> model([], [], [], 'term')
  1 个评论
Joe
Joe 2017-10-4
One additional suggestion... if you ever find yourself in a situation where
model([], [], [], 'term')
does not work because Simulink "defers" the termination and you're stuck... Try the following,
set_param(gcs, 'SimulationCommand', 'stop')

请先登录，再进行评论。

更多回答（1 个）

Lukas
Lukas 2018-9-21
If the above commands doesn't help and you still see:
model([],[],[],'term')
Warning: Termination of 'model' deferred
then just try to execute model([],[],[],'term') multiple times.
I think this helps in case model had been compiled multiple times without terminating it. For example during debugging of a function that does this.
  2 个评论
Manu Madhu
Manu Madhu 2020-6-18
Thank you, it works
rsating
rsating 2024-6-27
Repeated "term" commands worked for me too. Thanks!

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by