MATLAB switching problem in designing an Active Power Filter
2 次查看(过去 30 天)
显示 更早的评论
Hi everyone. I am new in MATLAB. I design an Active Power Filter (APF) with constant frequency integration control for single phase application. I having some switching problem. Previously I was using PSCAD software and I achieved a good result with current total harmonic distortion less than 4%. However, in MATLAB I am getting the result but that has a lot of noise or ripple as shown in the figure below.
May I know why this happen and how can I solve it?
Result with PSCAD:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/156126/image.jpeg)
Result with MATLAB (noisy):
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/156127/image.jpeg)
Thank you very much for your help.
0 个评论
回答(1 个)
Joel Van Sickel
2023-5-2
This is an attempt to clean up Matlab answers. I realize this answer is too late to be useful for the asker:
For this type of problem, you would need to have provided the model to get a resonse. There is likely something wrong with the implementation of the model or controller in Simulink that isn't obvious and would require viewing the model in detail to find. Both tools are capable of simulating the same types of systems and will provide similar results for the same system if modelled correctly in both tools.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Switches and Breakers 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!