Problem related to powergui block

3 次查看（过去 30 天）
saptesh pandit
saptesh pandit 2016-10-11
回答： Prabhat Singh 2020-1-13
whenever I run my model following errors occur how do I solve these.
1)Error in port widths or dimensions. Output port 1 of
'practice/powergui/EquivalentModel1/Gates/From2' is a [1x2] matrix.
2)Error in port widths or dimensions. Invalid dimension has been specified
for input port 2 of 'practice/powergui/EquivalentModel1/Gates/Mux'.
I am using 1x2 size matrix which is the requirement. How do I solve these problems.

请先登录，再回答此问题。

回答（2 个）

ALBERT ALEXANDER STONIER
It is only because of the dimensions which you have specified for the signal. Kindly change the dimensions and proceed with.
  1 个评论
Jasmine Jones
Jasmine Jones 2018-4-17
I have tried to edit powergui and I still have the same errors? My simulation will not work without it but with the powergui in I get the fault mentioned above?

请先登录，再进行评论。

Prabhat Singh
Prabhat Singh 2020-1-13
I am not able to see FFT analysis by powergui block. Simulation run but after clicking on FFT analysis it is not sowing the resuts. I have made all the settings properly is scope also.

类别

在 Help Center 和 File Exchange 中查找有关 Transforms 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by