Canny Edge Detection - Automatic/Adaptive Thresholding

14 次查看（过去 30 天）
Philip
Philip 2012-2-29
回答： Omer Moussaffi 2014-5-22
I have read in the docs for the 'edge' function that when a low and high threshold are not defined when calling the 'canny' edge operator, MATLAB automatically determines the best values for the given image. The threshold values can be obtained by specifying outputs to the argument. But can anyone explain (simply, if possible) how MATLAB calculates these threshold values, and whether the process can be slightly adjusted to bias toward only the stronger edges being identified?
I know the doc files hint at how this is done, but I don't quite understand it...

请先登录，再回答此问题。

回答（4 个）

Sean de Wolski
Sean de Wolski 2012-2-29
You could place a break point in the subfunction parse_inputs() of edge().
edit edge
Scroll down and place breakpoint and follow the variable Thresh.
  1 个评论
Philip
Philip 2012-3-15
Thanks, I have done this, and found this line of code that sets the high threshold value:
highThresh = find(cumsum(counts) > PercentOfPixelsNotEdges*m*n,1,'first') / 64;
where 'counts' is a histogram of the gradient magnitude of the image (64 bins), PercentOfPixelsNotEdges is a constant (0.7), and m and n are the image dimensions. The low threshold is simply calculated as a multiplication of this output with a ThresholdRatio constant (4).
Is anyone able to help me figure out exactly what 'PercentOfPixelsNotEdges' = 0.7 means. As mentioned, it is a constant, so this value stays the same no matter what image is used...

请先登录，再进行评论。

Aaditya Kalsi
Aaditya Kalsi 2012-3-28
It means that out of the detected edge values, 70% of the pixels will not be considered edges. Values higher than the 70th percentile among the values in the Edge image will be considered as edges.
That's what it seems like to me!
David Young
David Young 2012-3-28
The documentation ought to be explicit about points like this! I think you could reasonably put in an enhancement request.
When I use Canny, I often call the function twice. The first time I capture the second result (and discard the edge image), and then I multiply the returned threshold by a constant to slightly increase or decrease it to get the threshold argument for the second call. Not very efficient, but it does allow reasonable control of edge density.
Omer Moussaffi
Omer Moussaffi 2014-5-22
Hitching on Phillip's question - can I use the automatic thresholding with the Matlab Coder?

类别

在 Help Center 和 File Exchange 中查找有关 Object Analysis 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by