Why I am getting this error "No connector at hos"?
1 次查看(过去 30 天)
显示 更早的评论
I'm trying to read the sensor data from mobile but when i am entering the ip address of my computer it shows "No connector at host". My system connected with LAN and my phone is connected with wi-fi. I don't know how to rectify the problem. Kindly anyone help me with this. Thanks in advance.
0 个评论
回答(1 个)
Walter Roberson
2016-10-23
On your system running MATLAB you must give the command
connector on
and then you must start up MATLAB Mobile on your phone.
If your phone is connected with Wi-Fi to a router in your system then it is probably already being assigned a usable IP address on the same network as your host computer.
However, if your phone is connected with Wi-Fi directly to your host computer, to a Wi-Fi receiver on there, then it would be on a network interface that might be using a different IP address or even different network entirely than the network being used for Wi-Fi. For example, my computer uses an address ending in .135 on the LAN, but I have its direct Wi-Fi interface set to end in .134 so my phone would need to be told to access the .134 address to talk to my computer directly.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!