How to use Simulink to solve for Piezoelectric Transducer?

25 次查看（过去 30 天）
Jake Rabinowitz
Jake Rabinowitz 2016-11-9
评论： abbas 2023-12-14
Hello all,
I am trying to set up a simple Simulink environment to simulate the output voltage of a piezoelectric stack in response to incident acoustic radiation. I wanted to verify the setup by running the simulation at a single incident force. I have fully defined my piezo stack based on material values, such that there are no variables in the system (confirmed via findVars command). However, when I attempt to run the simulation, I receive a "number of variables exceeds number of equations" error. I suspect that it is because the system does not have any equations to solve, but I was under the impression that these equations were built into the relevant blocks. Thus, I am now stuck.
I have attached a screenshot of the setup (I was not permitted to attach the file; I am happy to send to any prospective helpers). Any advice would be greatly appreciated, as I have only limited Simulink experience.
Thanks, Jake
  3 个评论
显示 1更早的评论
KARTHIKEYAN SARAVANAN
KARTHIKEYAN SARAVANAN 2022-12-21
can you share simulink file to my mail id karthikeyanthyristorfamily@gmail.com
abbas
abbas 2023-12-14
greetings sir
kindly email me your simulink file please Email: abbskhan889@gmail.com

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Hari Desanur
Hari Desanur 2016-11-14
In your model, you will have to add domain reference blocks. An electrical reference block to the blue colored connection and a mechanical reference block to the green colored connection.
By replacing the 'constant' block with a 'step' function block, I did not see any errors.

类别

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by