How to set multiple ports for a step input block

5 次查看（过去 30 天）
Teo Samuel
Teo Samuel 2012-3-8
Hi all,
Is it possible to set multiple ports for a step input block? I am tying to run two models with PID controller in simulink and I need two different step signals to be used as the set input for both models.
It is troublesome by using two step signal blocks as I need to set the final value of the signals seperately. So how can I set the final value of the two signal in one identical parameter setting GUI? Is it possible?
Please advice. Thank you very much.
Regards

请先登录，再回答此问题。

采纳的回答

Jarrod Rivituso
Jarrod Rivituso 2012-3-9
I believe you can use a single Step block, and then for the various parameters (such as the Final Value parameter) you can set a vector, such as
[-1 1]
This will cause the Step block to output a vector signal, and you can demux the signal to get each element (or use the Selector block).
  2 个评论
Teo Samuel
Teo Samuel 2012-3-9
Great answer, thank you so much...By the way, do you know is there any way to reset the value in the step signal block if a certain condition is met in the simulink? Thank you very much.
Regards
Jarrod Rivituso
Jarrod Rivituso 2012-3-12
Hi Teo,
I would use the Relational Operator block and perform the logic myself, if I was doing something like that.
Hope this helps!
-Jarrod

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Event Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by