清空筛选条件
清空筛选条件

why the "power_fftscope" and FFT analysis tool in powergui give different results?

2 次查看（过去 30 天）
Mudasir Ahmed
Mudasir Ahmed 2016-12-15
评论： Massimo Paglia 2017-7-3
hi
I measure the FFT of a signal name "voltage3" using powergui as shown in fig 1st. then I use the instruction "power_fftscope (voltage3)" and results are attached in fig. 2nd. but there is a huge difference in THD. Fundmentamental frequency and harmonic values. kindly help me why this difference comes.
Regards mudasir
  1 个评论
Massimo Paglia
Massimo Paglia 2017-7-3
Looking into the pictures it seems that you have entered a different period. You should write 60 Hz to the power_fftscope GUI in order to compare your results.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by