How to reset parameters in a simuink block when a certain condition is met in the simulink loop

2 次查看（过去 30 天）
Teo Samuel
Teo Samuel 2012-3-11
Hi all,
Is there any way to reset parameter in a simulink block when a certain condition is met in the simulink loop???
Please advice, thank you very much.
Regards

请先登录，再回答此问题。

采纳的回答

Kaustubha Govind
Kaustubha Govind 2012-3-12
It is not possible to change a block parameter based on the value of another signal. However, it is possible to perform a "reset" for some blocks' states - for example, the Integrator block by using its reset port.
  2 个评论
Teo Samuel
Teo Samuel 2012-3-13
Dear Miss Govind,
Thanks again for your reply. So, it seems like impossible to reset a certain simulink block parameters during simulation, by the way the set_param command mentioned in the article you have shown must be performed in the command window right?
So, one last hope...is it possible to achieve the parameter reset by using relational operator blocks?? Someone suggested me to use that, I still need to figure it out, but before that just need to assure how high the possibility it could be achieved. Thank you very much.
Regards
Kaustubha Govind
Kaustubha Govind 2012-3-14
Yes, the set_param command needs to be run from the MATLAB command window. As for the use of relational operator blocks to reset parameters - I'm not sure how this is done. Could you provide more information about how you plan to implement this suggestion?

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Scopes and Data Logging 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by