Why can't I toggle GPIO at high frequencies

1 次查看（过去 30 天）
lih36
lih36 2017-1-9
I'm trying to toggle a set of GPIO pins on a F28335 DSP using Simulink (2012b). I notice that when I set the sampling time of the model to be high enough, the toggling frequency decreases.
If I set the step time of the model at 5 us, it will toggle every 5 us. But when I set the step time to be 1 us (5x increase in frequency), the toggle will only happen every 3 us. If I set the step time to be 0.1 us, there is no toggling happening whatsoever.
Is there some overhead or inefficiencies in Simulink-generated code that is keeping me from toggling these pins at high frequencies? The hardware should have no problem accommodating this since the DSP is on a 150 MHz clock. Any advice would be appreciated.
-HDL

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by