How to Trigger based on a incoming data value?

2 次查看（过去 30 天）
Rohan
Rohan 2012-3-16
hello, I am aquiring a serial data from a sensor via xpc target. The sensor sends data in a continuous mode. I want to seperate the data byte from the packet of data. For that I want to trigger the data on the basis of a header byte say(0xC2).So that i can know where the packet starts. Can you suggest a way to do this
  1 个评论
Walter Roberson
Walter Roberson 2012-3-16
Is it certain that 0xC2 can never be part of the data stream, and can never occur as a checksum byte?

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Rajiv Ghosh-Roy
Rajiv Ghosh-Roy 2012-3-20
Please take a look at the white paper "xPC Target Serial Communication" available here http://www.mathworks.com/tagteam/68353_xPCTargetSerialCommunication.zip

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by