Show calibrated value as acquiring

5 次查看（过去 30 天）
Kay
Kay 2011-3-15
Hello, I hope someone good at Matlab can help me on this issue!
What I can do so that the data in "getdata" is calibrated? What I mean is, can the scope show the units that i want instead of volts? I want to see the real time plot with the actual unit (mmHg, in my case), not volts!
thank you so much!

请先登录，再回答此问题。

回答（1 个）

Walter Roberson
Walter Roberson 2011-3-15
You need to tell us more about what kind of device you are reading from and which interface driver you are using to the device.
  2 个评论
Kay
Kay 2011-3-15
I am using the USB-6009 from National Instrument!
My program is to read the blood pressure and blood flow from a rat!
After acquiring the data, I calibrate and transfer the data to mmHg and mL/min!
So, the data in "getdata" is all in Volts, I wondered if i can calibrate the data once it gets into "getdata"! (since i want to plot it at the same time!)
Walter Roberson
Walter Roberson 2011-3-15
I would suggest using getdata() with 'type' 'native', shifting the resulting integer up so that the lowest possible value is 1, and using that as an index into a lookup-up table of calibrated values (I'm assuming the voltages might not be linear response.) I don't know at the moment how you would change the legend on the scope.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Analog Input and Output 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by