How can I log executed cells (when using editor in cell-mode) to command history?

Question

Martin Hoecker 2017-2-26

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/326998-how-can-i-log-executed-cells-when-using-editor-in-cell-mode-to-command-history

回答： Ankita Nargundkar 2017-3-6

I am using scripts in cell mode to be able to quickly run a few lines on pressing Ctrl+Enter. However, when I run lines this way, they don't show up in the command history. Is there any way to enable this?

The only alternative I know is to highlight the code I want to run, and to then press F9. This copies the code to the command line and executes it, so it ends up in the command history (which is good). But the workflow is not as nice as the Ctrl+Enter of cell mode.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Ankita Nargundkar 2017-3-6

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/326998-how-can-i-log-executed-cells-when-using-editor-in-cell-mode-to-command-history#answer_257548

I am assuming by cell mode you mean "Run Section" option because that is what happens when you use Ctrl+Enter. Yes, it is not shown in the command history because that is the expected behavior.

Cell mode (Run Section) is to debug applications and run a module of code at once. Even if you are unable to show commands in command history all variables still exist in workspace.

For more information you can refer to this stack overflow discussion and this MATLAB documentation