There is an endless loop in the function "getCompleteIntervals".

7 次查看（过去 30 天）
Cole
Cole 2017-5-18
评论： John Henry Campbell 2023-7-24
Hi, there.
When the parfor loop finished, the program dropped into an endless loop in the function "getCompleteIntervals".
This function is in the file "remoteparfor.m".
Is there any solution? Thanks.
The screen capture is as follows. The variable r is empty.
  6 个评论
显示 4更早的评论
Hongbiao Chen
Hongbiao Chen 2018-1-29
编辑：Hongbiao Chen 2018-2-2
I have encountered the similar problem. My program (using parfor) works fine in my labtop (Win8) but would be stuck in the workstation (MATLAB2016b, Windows Server 2012, Dell T630, 2 CPU and 32 cores Xeon®). In the code block above, 'r' is always empty while 'obj.CaughError' is empty too. Update: Fixed. The key resaon in my problem is the size of data. After dividing the data into smaller pieces, the problem sloved (my output result may >2G).
Victor Gonçalves
Victor Gonçalves 2018-2-21
编辑：Victor Gonçalves 2018-2-21
I have the same problem using the optimization toolbox GA function with parallel processing enabled on 2016b. After running a generation, the parfor becomes stuck in this loop. My setup is a Intel Xeon 4 cores, Win10, 16GB RAM.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

Paul Hoffrichter
Paul Hoffrichter 2020-6-22
编辑：Paul Hoffrichter 2020-6-22
I had a similar problem in MATLAB 2020a. I saw two single pre-allocated arrays defined before the parfor-loop. I made them double. That allowed what appeared to be an infinite loop in remoteparfor to complete in the normal expected timely manner.
  3 个评论
显示 1更早的评论
Paul Hoffrichter
Paul Hoffrichter 2021-5-31
编辑：Paul Hoffrichter 2021-5-31
Every problem is different, of course. In my case, I had learned that it is known that parfor calculations can produce slightly different results from a for-loop due to truncation/roundoff errors creeping in a different manner even for Matlab built-in functions.In my case I narrowed the problem down to a threshold check that was true in for-loop, but false in a parfor-loop. By changing the single precision to double precision, the threshold check remained true in both for- and parfor-loops.
John Henry Campbell
John Henry Campbell 2023-7-24
Hi! I am using the ga function in matlab in tandom with Abaqus. The ga function will run for about a day or two but then the workers will run into the issues describe above by the original post. Are these pre-allocated arrays specific to a parfor loops or were these array that needed to be chaned to double specific to the code you were running? Also, do you think you could post the code that you had to end up changing if it is related to the parfor loop specifically?

请先登录，再进行评论。

DeepSea
DeepSea 2021-8-15
I've been stucked in this problem for couples of weeks, and fixed it by removing "continue" in an if-judgement and a for-loop.
for CondA
...
if CondB
continue; % Avoid using "continue"
end
...
end

类别

在 Help Center 和 File Exchange 中查找有关 Parallel for-Loops (parfor) 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!