Question about the "enable" block.

2011 3 18
3 个回答
回答已采纳
5 次查看（30 天）

0 个投票

Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?

请先登录，再回答此问题。

更多回答（2 个）

Arnaud Miege
Arnaud Miege 2011-3-18

0 个投票

Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud

0 个投票

I already read this doc, but how do you do to put your initial condition in the "initial output" box, when you have a bus ? For example, in my bus, I have enumerated, double, maybe an other bus, etc, so I don't have just one value to initialize.

2 个评论
显示 无 隐藏 无

Guy Rouleau
Guy Rouleau 2011-3-22
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
Kaustubha Govind 2011-3-23
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Iterator Subsystems 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by