track position using a feedback
1 次查看(过去 30 天)
显示 更早的评论
Hi, I have designed a controller using simulink. This model controls the velocity reference. Now,i want to give the controller a position reference and it should be able to reach the position given as the reference. For this, the following steps follow:
1) Position reference is given 2) Position converted to velocity signal 3) Velocity will be controlled until the vehicle reaches the defined position
I have seen the second order integrator which converts the given velocity into position, But i am not quite sure as to how to use this. Any help is much appreciated
Thank You
0 个评论
回答(1 个)
Naty Shemer
2017-7-12
Hey,
It's a bit hard without a code example. In general once you have managed to complete the velocity loop and control it as desired it is now defined as the inner loop. You need to complete the PID (or different controller) for the outer loop.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Classical Control Design 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!