Two bit DAC code?

3 次查看(过去 30 天)
Darsana P M
Darsana P M 2017-7-30
Can you give me the matlab code for a two bit DAC?? For eg, if the digital input is 1101110010.

回答(1 个)

Walter Roberson
Walter Roberson 2017-7-30
Sorry, no. As best I can tell at the moment, none of the devices supported by MATLAB are 2-bit DAC, so there is no MATLAB code.
It is possible that you might be able to find a 2-bit DAC attached to I2C or SPI on Arduino, I suppose. Or Raspberry Pi. We would need more information about your set-up for that possibility.
  2 个评论
Darsana P M
Darsana P M 2017-7-30
Thanks you sir. Can I assign values 00=0v ,01=1v ,10=2v, and 11=3v by taking bi2de (binary to decimal) conversion. Can it make a continuous wave? actually I want to convert digital input to analog form for applying it as an input to analog beamforming
Walter Roberson
Walter Roberson 2017-7-30
desired_output_voltage = DigitalSignal(1:2:end)*2 + DigitalSignal(2:2:end);
However, at that point you are stuck. Nothing you can do inside a pure program can convert the numbers in desired_output_voltage into actual voltages. To convert to actual voltages you need to talk to hardware, such as a Digital To Analog convertor device, or an Audio Output device.
What kind of hardware are you using for analog beamforming? By definition, analog beamforming must be done in hardware (analog).
What I suspect that you want to do is generate a digital signal that models a waveform, perhaps as rectangular pulses or perhaps as sine waves, and that you then want to use digital techniques to modify that digital signal. No hardware would be required for that.

请先登录,再进行评论。

类别

Help CenterFile Exchange 中查找有关 Beamforming and Direction of Arrival Estimation 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by