how to stop a motion at a right position and simulate Deformation

1 次查看（过去 30 天）
Dongbo Chang
Dongbo Chang 2017-8-2
编辑： Steve Miller 2018-3-6
I want to build a model to simulate motion of screw. Below Picture shows my Model. The green part is a screw, and the gray part is a solid mass. But now there is a problem about the model, i.e. the screw will across the mass. But in fact this is of course impossible. So how can i set the model, when the head of screw contact of the mass, this motion can stop or only a deformation but not across the mass.

请先登录，再回答此问题。

采纳的回答

Nicolas Schmit
Nicolas Schmit 2017-9-7
编辑：Steve Miller 2018-3-6
You can connect the lead screw to a hard stop from Simscape foundation library.
how to connect lead screw joint with translational hard stop

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Multibody 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by