Warning: Cannot query I2C bus speed.

2 次查看（过去 30 天）
Mario Frischmann
Mario Frischmann 2017-8-30
评论： Morteza aliyari 2017-11-24
Hy everybody,
I am usining a Raspberry Pi 3 Model B V1.2 and the Support Package for Raspberry Pi.
With the Matlabcommand
mypi = raspi
I can connect to my Raspberry Pi but at the first time I use this command I alwas get following warning:
Warning: Cannot query I2C bus speed.
If I use the commands
disableI2C(mypi)
enableI2C(mypi,400000)
once and clear the variable mypi and try the comment mypi = raspi again it can query the I2C bus speed (40000)
Can anyone help me so it will work at the first time? I use Matlab 2016b
Thank you very much
  1 个评论
Morteza aliyari
Morteza aliyari 2017-11-24
hi,i recommend enable i2c from raspberry pi terminal with: sudo raspi-config and add bus speed to your config.txt on rpi3b. it work for me.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Manish Annappa
Manish Annappa 2017-9-7
In order to get more information on the issue, post the output of the following commands
a) Create connection to Raspberry Pi (for the first time)
>> mypi = raspi
b) List all the available I2C bus available and their speed
>> mypi.AvailableI2CBuses
>> mypi.I2CBusSpeed
c) Scan all the I2C buses available to get its address. '<name>' is obtained from the output of mypi.AvailableI2CBuses.
>> scanI2CBus(mypi,'<name>')
d) Create a connection to all the addresses obtained in the above step for every I2C bus.
>> i2cdac = i2cdev(mypi,'<name>','<address>')
e) Write value to every I2C bus connected in above step
>> write(i2cdac,4092)
Refer to the link below for more information on the commands:
https://www.mathworks.com/help/releases/R2016b/supportpkg/raspberrypiio/ug/use-the-i2c-interface-on-the-raspberry-pi-hardware.html

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB Support Package for Raspberry Pi Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by