Mapping objects on a table onto MATLAB grid using HC-SR04 ultrasonic sensors with Arduino

8 次查看（过去 30 天）
Ammar Babikir
Ammar Babikir 2017-8-31
回答： Kris Fedorenko 2017-9-6
Hi everybody,
I'm using an HC-SR04 ultrasonic sensor with Arduino to detect objects on a table and have it "plot" that detection on a grid.
I essentially want to "map" objects it detects on the table onto a grid in MATLAB. I am not using a servo motor to rotate the ultrasonic sensor. I am only detecting objects that are right in front of it in its line of sight.
I started off with an arbitrary grid:
I was thinking of representing each object that I find on the table as a block that's "shaded" in.
The general idea of how I want to do this is to have an ultrasonic sensor detect an object and then have it populate a "block" of the grid.

请先登录，再回答此问题。

回答（1 个）

Kris Fedorenko
Kris Fedorenko 2017-9-6
Hi Ammar,
If I understand your question correctly, you would like to be able to represent detected objects as a grid. I think you should consider using heatmap. Here is a simple example:
objects = zeros(10, 10);
objects(3, 4) = 1;
objects(5, 8) = 1;
heatmap(objects)
Hope this helps!
Kris

类别

在 Help Center 和 File Exchange 中查找有关 Sensors 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by