Connecting to xPC Target using Simulink Real-Time R2017b

9 次查看（过去 30 天）
Jan Zbinden
Jan Zbinden 2017-10-12
评论： Mahmoud Hadi 2018-2-19
Hi I'm currently trying to port a project from an old Matlab/Simulink version to R2017b. The host PC connects to target PC when I use the 2010 as well as the 2013 version of SRT. But If I create a boot CD with the exact same settings as for the other versions in 2017b, I can't connect to the target PC anymore. I can't even ping the IP of the target PC using CMD (This was possible when I booted the target with 2010 or 2013). Does anybody have an idea what could be wrong?
  1 个评论
Prashant Arora
Prashant Arora 2017-10-17
Hi Jan,
Can you check if the version of SLRT found using ver('slrt') is same as the one showed on target screen?
Prashant

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Jon Lobo
Jon Lobo 2017-10-24
You should connect your target to a monitor. I suspect that the kernel is not booting correctly, which is preventing you from being able to ping successfully. If there is an error message on the target, that will help to debug this.
  1 个评论
Mahmoud Hadi
Mahmoud Hadi 2018-2-19
Hello Jon,
I am also having the same issue even though the XPC boot properly and shows no errors on the screen. Is there any known issues on some Ethernet cards? I am using a PCI card (Intel 8255X) and I a made sure that the built-in Ethernet port is disabled in BIOS.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by