Why does hilbert tranformer give a phase-shifted but amplitude-reduced signal?

7 次查看（过去 30 天）

Yuzhen Lu 2017-11-10

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/366331-why-does-hilbert-tranformer-give-a-phase-shifted-but-amplitude-reduced-signal

评论：叶 2022-12-12

I have performed hilbert transform by using a FIR hilbert filter rather than the matlab built-in hilbert function. An example code is as follows:

fx = 10;
t = linspace(0,1,512);
x = 0.5*cos(2*pi*fx*t); %sampled signal
h = firpm(26,[0.1 0.8],[1 1],'h');   % hilbert filter
xh = conv(x,h,'same'); %hilbert transform of x
figure;
plot(t, [x;xh]); legend('Original','Transformed');

The resulting figure is given as follows:

How to address the problem to obtain the result equivalent to that by using hilbert function ?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Honglei Chen 2017-11-13

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/366331-why-does-hilbert-tranformer-give-a-phase-shifted-but-amplitude-reduced-signal#answer_290852

在 MATLAB Online 中打开

The phase shift is expected so I assume you are talking about the amplitude? This is because the filter is not ideal. If you do a

fvtool(h)

You can see that the magnitude response is not unity when the frequency is close to DC or Nyquest. In your case, the signal frequency is 10 and the sampling rate is 512, so that is close to DC so you see the attenuation. if you change your sampling rate to, say, 128, then the result would be similar to what you get from hilbert.

HTH