How can I detect peaks in real time with using Simulink?

Question

ali ihsan taran 2018-2-1

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/380192-how-can-i-detect-peaks-in-real-time-with-using-simulink

回答： Rodney Case 2019-3-12

Hello I have really strong issue with this topic. I have searched and examined several articles about peak detection in real time with using simulink. However I couldn't find suitable algorithm etc. Actually I am asking that algorithm but it would be better if anyone has worked this with Simulink. By the way I know about Matlab Function in Simulink but my problem is I couldn't adapt that in real time. Any comments or ideas will be fine. Many thanks in advance.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Rodney Case 2019-3-12

2
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/380192-how-can-i-detect-peaks-in-real-time-with-using-simulink#answer_365047

I had a similar problem. Here's how I approached it. I have a periodic signal where the fundamental frequency is known a priori. I want to output the peak-to-peak amplitude for the most recent period of the fundamental frequency as it evolves throughout my simulation. I used a Tapped Delay block in Simulink to sample the signal and output the most recent n samples. I chose the sample period for the block such that the block output will always contain slightly more than 1 full period at the fundamental frequency. Consequently, the Tapped Delay block contains n samples for 1 period of the fundamental frequency. Then, I used max and min blocks to get the highest and lowest values from the Tapped Delay. The difference between these two values is the peak-to-peak amplitude of the most recent fundamental period but I also have access to the most recent peak values. Sampling the peak-to-peak amplitude signal at the fundamental frequency provides a nice clean history of peak-to-peak values for plotting.