Simulink - Initial condition for first iteration only

55 次查看（过去 30 天）
Aviad Aviad
Aviad Aviad 2018-4-3
编辑： Abdolvakil Fazli 2018-12-18
I've built a closed-loop model on Simulink and I used a Memory block in order to delay the feedback signal. The problem is that Memory block delays every input signal by one step and I would like to use an initial value for the first step only and then use the computed value for the second step and so on.
Is there a way to accomplish this is Simulink?
Thanks in advance.

请先登录，再回答此问题。

回答（2 个）

Birdman
Birdman 2018-4-3
Run the attached model. I simply made a logic where the clock of the simulation is compared to a constant, let's say your sampling time(assuming you are working with fixed step). Then, At the very first step, it enables Memory block to be active via a MATLAB Function(see the content of MATLAB Function and try to understand), and after it passes first step, direct feedback is applied. Try to understand and adapt this into your problem. Hope this helps.
  8 个评论
显示 6更早的评论
Aviad Aviad
Aviad Aviad 2018-4-4
The error is solved, but now due to the addition of delay block - the model doesn't act as expected: The expected result should be that the "AC Temp" figure and the "Calculated AC Temp" figure are the same except for the first step but due to the addition of delay - the "AC temp" is always "one step" behind instead of being equal (I attached the figures).
(I altered your delay block - only added an initial value of 20).
Birdman
Birdman 2018-4-4
Oh, that is because you set your Fixed step size to 100. You should lower it to see more accurate results. Do you have any logic setting the step size to 100?

请先登录，再进行评论。

Abdolvakil Fazli
Abdolvakil Fazli 2018-12-18
编辑：Abdolvakil Fazli 2018-12-18
Hi,
I have trouble setting the initial value of the adaptation block in simulink attached in this post. I am dealing with a loop in the input of this loop I take one data x (or say a sample) and calculate y according to that x , and adaptation vector (A), in adaptation block, I would update A according to the previous value of x,y,z and A , then I report A to predistortion block , and this loop is turning. My problem is the initial value of A in the first step; It has to be set as ones(1,65) just in the first time ; I do not know how to do it. Because if you set it in Pred block as ones(1,65) in each sample you will be facing with A=ones not an updated version of A. Someone suggested me using clock and counter, I do not know how for I am beginner in simulink. If anybody has any idea about implimentation of this method, or if you have another suggestion , it would be appreciated.
Thanks in advance

类别

在 Help Center 和 File Exchange 中查找有关 Event Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by