How can I visualize signals evolving time by time on a dashboard, while simulation is running?

1 次查看（过去 30 天）
Alessio Conte
Alessio Conte 2018-5-5
评论： Alessio Conte 2018-5-8
I would like to see how signals change in time, time by time and not all at once at end. I tried to understand it from the example sldemo_fuelsys (Fault-Tolerant Fuel Control System) but I could not. In few words I would like to see signals evolving on a dashboard while simulation is running.
  3 个评论
显示 1更早的评论
Sara Nadeau
Sara Nadeau 2018-5-8
Your simulation may just run very quickly. If you have 18a, you can use simulation pacing to slow down the simulation relative to clock time so you can see signals evolve through the model as the simulation runs.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Ameer Hamza
Ameer Hamza 2018-5-5
Although you can visualize a signal using scope. But if you want to use dashboard then use Dashboard Scope in Simulink to visualize the signal. A sample file is attached.
  6 个评论
显示 4更早的评论
Ameer Hamza
Ameer Hamza 2018-5-5
I checked, and it is also working at full speed. You are able to observe it because it is running up to 2000 seconds.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Acceleration 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by