Info

此问题已关闭。 请重新打开它进行编辑或回答。

How can I change the block substitution to match the dimensions of the block in the Simulink model

3 次查看（过去 30 天）
sujit bhuyan
sujit bhuyan 2018-5-26
关闭： Sabin 2023-9-27
In "linearize(modelname,io)" using block substitution the input-output dimensions of the substituted block linearizations the input-output dimensions of the block being replaced. The block substitution for pv_hybrid_phd_model/3-Phase Dynamic Load/Model/Discrete/Unit Delay2 has dimensions [1 x 1] and the Simulink block has dimensions [2 X 2]. Change the block substitution to match the dimensions of the block in the Simulink model.
  1 个评论
utsav sharma
utsav sharma 2019-5-12
Why no answer on this question? I am facing the same difficulty using the control system tuner for PMSM drive. Simple PI controller is not getting tuned by control system tuner and this same messgae is flashing over and over. Kinldy help on this issue.

此问题已关闭。

回答（0 个）

此问题已关闭。

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by