Use add_line on a line?

4 次查看（过去 30 天）
Lucas
Lucas 2012-6-12
I was wondering if you could get a handle from a line and draw a line from that to something else. Kaustubha helped me with the code below:
pc = get_param(outPorts{i}, 'PortConnectivity');
srcBlk = get_param(pc.SrcBlock, 'Name');
srcParent = get_param(pc.SrcBlock, 'Parent')
add_line(srcParent, [srcBlk '/1'], 'Out2/1', 'autorouting', 'on');
but if you have a sub system with 6 outports and you want to tie a line from each of them, the code above gets the previous block (subsystem) and ties a line from there to a new block. But it always ties a line from the first output, when I want one from each. So I if it’s possible to get a handle to a line, if you could use it as the source parameter in add_line.

请先登录，再回答此问题。

采纳的回答

Albert Yam
Albert Yam 2012-6-12
I don't know if there is another way, and I would like to know. This is my work around, it can get ugly, but works. I call it "x+1"
in_src = get_param(inblock, 'PortConnectivity');
in_src =in_src.Position;
add_line(sys,[in_src;in_src(1)+1 in_src(2)]); %draws a line from x to x+1
in_src =[in_src(1)+1 in_src(2)]; % save that location as source
outN = get_param(outNblock, 'PortConnectivity');
outN = outN.Position;
add_line(sys,[in_src;outN]);
So it technically works by drawing lines to position, rather than the block itself. You might get an unconnected line, but there is a script for that.
If there is better solution, I too would like to know.
  1 个评论
Albert Yam
Albert Yam 2012-6-12
You can use the block handle as a reference for that block, but if you want a name.
BlockName = get_param(handle,'Name');
Also,
<http://www.mathworks.com/matlabcentral/fileexchange/12352-delete-unconnected-lines>

请先登录，再进行评论。

更多回答（1 个）

Chiara
Chiara 2013-6-4
How can I specify left or right port to connect?
In my case,
in_src=get_param('new/source1', 'PortConnectivity')
gives a 2x1 struct array with fields: Type Position SrcBlock SrcPort DstBlock DstPort
Please tell me if I am wrong:
Where you wrote:
in_src =in_src.Position;
I should write:
in_src =in_src(1).Position; %for LConn1
in_src =in_src(2).Position; %for RConn1
and the same for outN. right?

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by