Doubt about matrices mxm
2 次查看(过去 30 天)
显示 更早的评论
Good afternoon.
I am new to the forum and new to programming with matlab, and I request your help with a topic:
I have the following code lines:
M_Kele_G=inv(M_Trans)*M_Kele*M_Trans;
M_Kele_global =['MK_G',int2str(f),' = M_Kele_G'];
eval(M_Kele_global)
where the variable "f" has an initial value of 1, it is a variable that grows one unit and that is contained in a for cycle. The result shown for a certain data entry:
MK_G1 =
500 0 0 -500 0 0
0 120 120 0 -120 120
0 120 160 0 -120 80
-500 0 0 500 0 0
0 -120 -120 0 120 -120
0 120 80 0 -120 160
If I in the matlab editor add the following line of operation: MK_G1 + MK_G1 matlab does the correct operation by adding both matrices, however I require some code that allows me to operate different matrices that vary according to the value of "f" , something like the following multiplication of matrices:
'MK_G',int2str(f) * 'MK_G',int2str(f)
I would appreciate your help in this regard. Thank you very much.
1 个评论
Stephen23
2018-7-18
"I am new to the forum and new to programming with matlab, and I request your help..."
The best advice you will get is to avoid creating or accessing variable names dynamically. Dynamically creating or accessing variable names is how beginners force themselves into writing slow, complex, buggy code (like you have). You can easily avoid doing this by using indexing.
采纳的回答
James Tursa
2018-7-18
编辑:James Tursa
2018-7-18
See the following link:
In short, you should rewrite your code to use cell arrays or nD arrays instead of using the variable naming scheme you are currently doing, which as you can already see makes it difficult to write good code.
E.g., instead of this mess:
for i=1:N
eval(['MyMatrix' num2str(i) '= MyFunction(MyVariable' num2str(i) ');']);
end
You can do something like this instead:
for i=1:N
MyMatrix{i} = MyFunction(MyVariable{i});
end
A lot nicer!
2 个评论
James Tursa
2018-7-26
Again, don't name variables dynamically like MK_G1, MK_G2, etc. Instead, use cell arrays or nD arrays. E.g., with cell arrays you could just to this if you wanted to get at the contents of the variable:
x = something
y = something
prueba = MK_G{px(j,1)}(x:y,x:y);
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Logical 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!