How do use fopen properly. Everytime I try I recieve an error.

Question

0 个投票

??? Error using ==> icinterface.fopen at 83
Connection refused: connect

Error in ==> theprogram at 8 fopen (t);

I am connecting a sourcemeter instrument to matlab to measure current by changing the voltage but everytime I try to connect to it I recieve this error message. Could someone please explain how to use fopen properly please?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

请先登录再关注

Answer 1

Walter Roberson 2012-6-18

1 个投票

That is a correct way to use fopen() itself.

However, you are attempting to form a TCP connection and whatever is at the destination address is not listening on that particular port. You need to check that you have the correct IP address, and check the port, and check that you have a route to that network. (If the instrument's IP address is not part of the same IP network as your regular connection, and you are not using a dedicated ethernet card to connect to the instrument, then you will need to have a router in between you and the instrument.)