HW/SW Co-design QPSK Transceiver example - Will only load Tx channel onto ADRV9361?

6 次查看（过去 30 天）
Hewy.j
Hewy.j 2018-8-14
评论： Hewy.j 2018-8-15
I've been following the example: HW/SW Co-design QPSK Transmitter and Receiver Using Analog Devices AD9361/ AD9364 Hardware Generation Model with the ADI RF SOM - ADRV9361. However once I have finished the process of synthesising and generating the HDL code for the FPGA, I check what's on the board using the following in the command window:
dev = sdrdev('ADI RF SOM')
info(dev)
and it returns:
Status: 'Full information'
ProtocolVersion: '9.0.0'
FirmwareVersion: '9.0.0 for Zynq, build Feb 26 2018 17:19:20'
HardwareVersion: '9.0.0 for Zynq, build Aug 14 2018 14:19:29'
HardwareRxCapabilities: 'Device does not have targeted Rx DUT'
HardwareTxCapabilities: 'Device has targeted Tx: DUT ChannelMapping = 1'
RFBoardVersion: 'RF Chip: AD9361, PCORE: version 9.0.98'
RFBoardRxCapabilities: 'BasebandSampleRate: [520.9kHz,61.44MHz]; CenterFrequency: [70MHz,6GHz]; NumChannels=2'
RFBoardTxCapabilities: 'BasebandSampleRate: [520.9kHz,61.44MHz]; CenterFrequency: [70MHz,6GHz]; NumChannels=2'
Notice only the TX channel has succeeded in arriving on the board - not the Rx - despite the HDL Workflow Advisor claiming successes throughout the process - I cannot figure out why. I've ensured the following:
- Reference Design is set to 'Receive and Transmit path'
- Channel mapping set to 1 (have tried setting to [1 2] and putting Rx and Tx on different channels - no luck)
- All target interface ports are correct
- Generated VHDL definitely includes code for Rx channel as well as Tx
Any advice would be greatly appreciated!
Kind Thanks
Harry

请先登录，再回答此问题。

采纳的回答

Neil MacEwen
Neil MacEwen 2018-8-14
Hi Harry,
You have hit a bug in our information returned here I'm afraid. If you target both transmitter and receiver, it will show up as only the transmitter in the info call. Rest assured both paths have been configured correctly. If you want to check this out for yourself, you can open the Vivado project that will have been generated by the workflow. It is in YourHDLDirectory/vivado_ip_prj/vivado_prj.xpr.
Sorry for any inconvenience.
Neil

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 RF Blockset Models for Transceivers 的更多信息

标签

产品


版本

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by