Doppler Velocity from I&Q channel

34 次查看（过去 30 天）
Muhammad Fayyaz
Muhammad Fayyaz 2018-8-20
评论： Aicha Sow 2021-8-12
I am new to this field and struggling to find doppler velocity from pure Doppler RADAR. I have I&Q channel, which I beleive is used to find doppler velocity by finding their phase difference ? Any sort of help would be much appreciated
  4 个评论
显示 2更早的评论
Muhammad Fayyaz
Muhammad Fayyaz 2021-8-12
Hi @Aicha Sow,
My research topic changed and later I used micro-Doppler for CNN models. Hence I did not continue with this one. Sorry I know it is not what you might have been expecting
Aicha Sow
Aicha Sow 2021-8-12
Hi @Muhammad Fayyaz I was indeed hoping for another answear. But thanks for taking the time to reply.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（3 个）

Honglei Chen
Honglei Chen 2018-8-20
There is a Doppler estimation example in Phased Array System Toolbox. You can find it at
https://www.mathworks.com/help/phased/examples/doppler-estimation.html
HTH
  2 个评论
Muhammad Fayyaz
Muhammad Fayyaz 2018-8-20
Hey there, The given example use PULSE RADAR. I have doppler radar CW. This particular radar will not give range or pulses. Hope I am able to clarify my point ?

请先登录，再进行评论。

Muhammad Fayyaz
Muhammad Fayyaz 2018-8-20
Thanks for the quick response. But I had already seen this example, which is for FREQUENCY MODULATED CW Radar system. I have purely CW system with no such information as required for FMCW or Pulse.
Honglei Chen
Honglei Chen 2018-8-20
If you are using a pure CW system, you cannot derive the range information. In that case you just mix the received signal with the transmitted signal, like what is done for range in the FMCW radar example. However, this time all frequency shifts are caused by Doppler shift. So just as shown in the FMCW radar example, once you get the beat frequency, that is your Doppler shift and you can then translate that to speed.
HTH
  2 个评论
Muhammad Fayyaz
Muhammad Fayyaz 2018-8-20
Is there any particular example related to that solution ? Because I havr received a code from company to output I&Q channel and the FFT output of it. What is required to translate that information to spped ?
Honglei Chen
Honglei Chen 2018-8-20
If you have FFT output, you can just locate the peak and get the corresponding frequency. To translate that frequency to speed, you can use dop2spped
https://www.mathworks.com/help/phased/ref/dop2speed.html
Note that this is for one way propagation. Since you are using a radar, you probably have two way propagation so you need to divide the result by 2 to get the correct speed.
HTH

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Detection, Range and Doppler Estimation 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by