I get the following message when I run my rtl sdr model

14 次查看（过去 30 天）

Derek Eccles 2018-9-17

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/419413-i-get-the-following-message-when-i-run-my-rtl-sdr-model

评论：行 2023-11-8

An error occurred while running the simulation and the simulation was terminated Caused by: An error occurred in the driver library. You can look up the full error message in MATLAB by executing message('ID','Message'): ID : sdrr:driver:LostConnectionSL Message: 0

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Joseph Kneeland 2021-1-27

Did you figure this out? I am having same error

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Ethem 2019-3-20

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/419413-i-get-the-following-message-when-i-run-my-rtl-sdr-model#answer_366403

>> message('sdrr:driver:LostConnectionSL','0').getString

ans =

'Lost connection to radio 0. Connect radio to computer and run model again.'

This may happen if you unintentionally unplugged the radio.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Ethem 2021-1-27

This message is generated when the computer looses connection to the radio. If your radio looks like it is still attached to the computer, you can try to unplug and replug it. If the problem repeats, try using another USB port. If the problem persists, you may have a defective radio.