Connection with target computer using ethernet board network simulink real time

7 次查看（过去 30 天）
Jose Briceño
Jose Briceño 2018-9-19
编辑： TJKoomen 2018-10-11
Hello,
I've seen that matlab suggest a PCI card ethernet connection with the target computer. https://www.mathworks.com/help/xpc/ug/command-line-pci-bus-ethernet-setup-multiple-target-computers.html
But is it possible to use the ethernet bus in the mother board of the target computer. That is because I don't have a ethernet card available.
I'm using matlab R2017a

请先登录，再回答此问题。

回答（1 个）

TJKoomen
TJKoomen 2018-10-11
编辑：TJKoomen 2018-10-11
This is possible; however the ethernet controller on your motherboard will have to be of a certain brand/familiy for it to be supported by Simulink Real Time. These families are listed in the dropdown "Ethernet Device Settings" in slrtexplr, Intel is generally very well supported. I use the following Intel ethernet cards in Simulink Real Time targets:
  • Intel 82579LM
  • Intel 82574L
  • Intel i350

类别

在 Help Center 和 File Exchange 中查找有关 Development Computer Setup 的更多信息

标签

产品


版本

R2017a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by