I have modeled 'Battery controlled DC motor using DC-DC converter (Bidirectional)' in simulink. Voltage keeps increasing?Why?Also, high discharge current.

8 次查看（过去 30 天）
Praveen Kumar
Praveen Kumar 2018-10-3
回答： vinod 2023-10-6
I have modelled battery controlled DC motor using a DC-DC converter with closed loop PI controller. When I am using a simple resistor as load it is working fine and able to maintain a voltage at 48V. But, when I use DC motor with similar parameters, voltage keep increasing. Even though armature current is around 20A, the battery is discharging at ~200A in this case. I have attached the model. Much appreciated if anyone can spot the mistake or give a solution.

请先登录，再回答此问题。

回答（1 个）

vinod
vinod 2023-10-6

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Electromechanical 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by