error in Euler method
显示 更早的评论
. could you please, check my code I did not get as the following pic.
for i=1:length(T)-1
x1(i+1)=x1(i)+dX1*h;
x2(i+1)=x2(i)+dX2*h;
v1(i+1)=v1(i)+dX3*h;
v2(i+1)=v2(i)+dX4*h;
end
2 个评论
James Tursa
2018-10-17
Closing your question and deleting your code and comments is not appreciated on this forum since it does not help anyone else later on. Please keep your questions and comments intact for everyone to see. Thanks.
Momo
2018-10-17
采纳的回答
James Tursa
2018-10-16
编辑：James Tursa
2018-10-16
You need to recalculate the derivatives at each time step. So all of the stuff that goes into calculating dX needs to be inside of your for-loop. Which means that all of the equations for this calculation need to be indexed. E.g., this
r=x1-x2 ;
should be this
r=x1(i)-x2(i) ;
etc.
4 个评论
Momo
2018-10-16
James Tursa
2018-10-16
Please post your current code.
James Tursa
2018-10-16
编辑：James Tursa
2018-10-16
So, when I wrote that you needed to have your derivative calculations inside of the for-loop, I was talking about your existing for-loop in your original posted code:
for i=1:length(T)-1
% Put all of your derivative calculations here
x1(i+1)=x1(i)+dX(1)*h;
x2(i+1)=x2(i)+dX(3)*h;
v1(i+1)=v1(i)+dX(2)*h;
v2(i+1)=v2(i)+dX(4)*h;
end
What you have done is create an additional for-loop (not my intention), and changed your original for-loop indexing (also not my intention). Instead, go back to your original for-loop indexing, and put your derivative code where I have the comment. Basically, at each step you need to recalculate the derivatives based on the current state.
James Tursa
2018-10-16
编辑：James Tursa
2018-10-16
Why are you using i=1:N instead of the original i=1:length(T)-1? Why are you overwriting dx1(i) and dx2(i) each step without doing the if-test part?
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Loops and Conditional Statements 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
