Run transmitter and receiver model in 1 model or 2 separate model in parallel

1 次查看（过去 30 天）
Ardeal Liang
Ardeal Liang 2018-10-18
评论： Ardeal Liang 2018-10-25
I have only 1 set of the hardware boards(AD-FMCOMMS4-EBZ(which is AD9364) and Zedboard). so I will run both transmitter and receiver on Zedboard.
1) if I run transmitter and receiver in one model in Simulink, I could receive the discontinuous sin wave shown in the following picture.
2) if I run transmitter and receiver in 2 different models in Simulink in parallel, I could not receive any data from receiver. This is really weird. I cannot figure out the reason and difference.
The example models I am using are:
https://ww2.mathworks.cn/help/supportpkg/xilinxzynqbasedradio/examples/frequency-offset-calibration-using-analog-devices-ad9361-ad9364.html
Transmitter model: zynqRadioFrequencyCalibrationTxAD9361AD9364SL
Receiver model: zynqRadioFrequencyCalibrationRxAD9361AD9364SL
*At present my questions are: a) how to receive continuous sin wave from receive?
b) why could I not receive any data from receiver if I run transmitter and receiver separately and in parallel?*
By the way: I am able to use command and Spectrum Analyzer to make sure transmitter is running while I start receiver.
I am suspecting whether there might be some special settings in Model Configuration Parameters

请先登录，再回答此问题。

采纳的回答

Paul
Paul 2018-10-22
Hi Ardeal,
The answer I gave to your other post should cover this question too. Link.
Hopefully that helps you.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 RF Blockset Models for Transceivers 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by